Everything About Android !

Flash Galaxy Ace Duos way to Stock Rom 2.3.

This time I will share the article on how to flash the Samsung Galaxy Ace Duos To Stock Rom Originally ie 2.3.6.
Immediately wrote to follow the steps below!

Tools and materials required:
  • Firmware Galaxy Ace Duos:  Click Here  to Download (if you've got, guns have downloaded again)
  • Odin v1.85: Click Here to Download
  • pit file Galaxy Ace Duos: Click Here to Download
  • USB Cable
  • Samsung Kies
  • Of course, the Samsung Galaxy Ace Duos (S6802)
Before performing Flashing, MAKE SURE !:
  • Driver Mobile has been properly installed on computers and mobile devices detected and installed properly when the phone is connected on the computer.
  • Samsung Kies is installed in the computer
  • Have enabled USB debugging on the phone in a way >> Settings> Applications> Development> USB debugging check.
  • Have Backup contacts to Sd Card 
  • Batteries in a state of full or at least 75%.
  • Ready Flashing with risk borne
Flashing process:
  • Turn off the phone and then go into download mode by pressing the button (power + home + vol. Down). Wait to see the construction drawings or triangles and inscribed download mode / downloading.
  • Open Odin, then enter his .pit files already in the extract with winrar.
  • Extract Firmware her, if in it there are only 2 files (1 .dll file 1 .tar.md5 file) enter the .tar.md5 files to PDA in Odin .... If in it there are 3 .tar.md5 file- her, then enter:
  • file "CODE" ---> PDA box   |   file "MODEM" ---> Phone box   |    file "CSC" ---> CSC box
  • Connect your phone to the computer using a USB cable, if it is plugged in will look yellow box labeled COM in Odin
  • Make sure that has been checked: AutoReboot, repartision, and f.reset time.
  • If steps 1-5 have been done well, click the START button in Odin. Flashing process takes min. 5 minutes (do not worry)
  • If Mobile ter-automatic restart and Odin have read PASS, then the flashing process has been completed successfully!
  • After booting and flame properly, unplug the USB cable and turn off Odin


Post a Comment